A hardware tech site for the rest of us.



Kingwin USB 3.0 Dock
HD5770 vs HD4890
HIS HD5870
CM 922 HAF Case
NZXT Panzerbox Case
Kingwin Lazer PSU
Tuniq Tower Extreme
Sentinel Mouse

Viper's Lair
Bjorn3D
nV News
Overclockers Online
ProClockers
Tec Central
Tweaknews
Virtual-Hideout
 

 

 

Enermax  EG375AX-VE Noisetaker

The PSU itself is a nice clean dark shade of blue with two fans. The intake fan on the bottom of the unit is 90mm, while the exhaust fan on the rear is 80mm in size.

 

On the rear of the unit to the right of the exhaust fan, you'll find a small control knob. This will control the fan's speed (both the intake and exhaust fans) to allow you to manually adjust it to give the individual user their preferred balance between cooling and noise level. The fan is also controlled by an internal thermostat to adjust to various loads placed on your computer, hence the moniker "Noisetaker".

This is also where the SmartFan specification comes into play. After you shut your PC down, the fans will continue to run for approximately two minutes to help cool down the interior components. This is a great inclusion, as once you turn the PC off, the CPU and various components are still at operating temps, but with no active cooling.

A shot of the PSU itself shows the various power leads. As stated, the Enermax Noisetaker also includes two SATA power cables. 

 

No more having to hunt down those adapters now.

Let's get into this "Separate 12V Rails" thing now. This is where the clean consistent power comes from. Normally PSU's run all power connections from one rail, which supplies power to all the devices hooked in. However, this unit provides separate 12V rails which are independent of one another to provide power to the CPU/MB and drives. With the upcoming release of the newer video cards and the power hungry Prescott CPUs, this will definitely come in handy.

The two mother connection leads are wrapped in a silver mesh screen and then encased in thick plastic to help with any interference. You'll also notice the single 12V 4-pin Molex connector grouped with the MB connectors. This is intended for those high end video cards that really suck in the juice.

 

The only thing wrong with this, in my opinion, is that the plastic makes these cables extremely stiff. They are hard to bend and route inside the case to keep them out of the way, especially if you're a neat freak trying to reduce cable clutter. The smaller the case, the worse it is. I tried this power supply in two different case, the Diabolic Minotaur and the Lian-Li PC-7323. I had very little problem with the cable in the Lian-Li, which a great big honking full tower case, but the Diabolic proved to be something of a challenge.
 

BACK                     NEXT

 


 



Legal Notice and Fine Print

All names and trademarks used herein are the properties of their respective owners.  The Overclocker Cafe
and its staff accept no responsibility for any damages incurred from deviating from your computer's factory settings.  All forms of correspondence sent in are viewed as eligible for public view unless mutually agreed to previously as otherwise.  The name Overclocker Cafe', its images and site specific logos are the Trademark and Servicemark of the Overclocker Cafe' Company. Williamsburg, Virginia.

All rights reserved.  All pages Copyright © 2000 - 2010 by R. Dean Barker.

Graphics
by Navin Amarasuriya

[ Privacy Policy ]