Overclocker Cafe - Lian Li Aquarium Side Panel

Lian Li Aquarium Side Panel

Below is the air pump. It has four soft rubber feet so any possible vibration it may make, will get dampened out. Power is obtained via a four-pin Molex connector.

Fish! The tails are hinged to give some flip action.

Installation

The one-page instructions included with the kit were brief. Then again, all we were doing was to mount a pump and a cathode on a bracket with double sided tape.

Here is a shot of the side panel from the front and the side so you can see the thickness of the water container area.

The plastic gravel, fish, and water are poured in from a small opening at the top of the container. Other than that, the panel installs like any other side panel.

The rear switch bracket we mentioned earlier had a small hole in it to "fish" out a translucent tube through, to allow you to connect the pump to a small nozzle on the base of the container. Those fish gotta breathe don't they?!

BACK NEXT