Thermaltake Perfect Light Series

The EL Fireball piece has one side of it coated with a medium bond adhesive.  I say medium bond because once we installed the EL PSU Fireball, removing it was simply a matter of pulling it off slowly and carefully.  No discernable loss of stickiness was apparent but I would expect that if you apply and remove it more than five or six times you'll lose your stick. was an even easier install than the window unit. 

Again the flash is an attention getter except...  The problem with the EL PSU Fireball is that you can't see it with the Xaser III case side panel closed.  So if you are looking at this mod for your Xaser III case, save your money.  However, if you mod your Tt PSU with this and install the now modded PSU in another type of case that leaves the power supply exposed you are in for a unusual treat.
 

 

EL Fireball for Xaser III Bezel

The Bezel EL Fireball is another Xaser III case specific mod.  This product is printed on the same EL type sheet as the other Tt "Perfect Light" accessories.  It is likewise controlled by the off / on throw type power switch.  Installation on the Bezel EL Fireball as a tad more involved than with the other pieces.  The Xaser III case front bezel must be partially disassembled in order to install it.  With the exception of my losing a screw due to my being careless, it installed easily.

        

And you thought you'd seen enough flash did you?  More were this came from.  I'm afraid by the time we finish this case is going to look like a fake fireplace.

BACK                    NEXT